For filling voids, pits, small holes, and crevices on coarse texture cement, cinder blocks or masonry surfaces, either interior or exterior, prior to finish coats of Crete Masonry Paint or other coatings.
PROPERTIES & ADVANTAGES – A vinyl emulsion material of plastic resins made into a heavy body consistency. Has very good hold out for finish coatings and usually stops water penetration from outside when used on exterior walls. It quickly and effectively fills open textured masonry, also very resistant to mud cracking.
FINISH – Flat (60° Gloss – 0-5)
COLORS – White
SPREADING RATE – 850 sq. ft. at 1 mil dry film thickness
DRYING TIME – 30 minutes tack free 2-4 hours dry
VISCOSITY – 85+ KU
THINNING – Water
SURFACE PREPARATION – Surface should be clean and free of granular materials. Not recommended for use over paints except on recommendation from TCB Paint Corporation laboratories. Apply full bodied in liberal quanities for best results. On extremely rough surfaces, a second coat may be preferred. Finish with 1 coat of Crete Masonry Paint or desired finish coating.
APPLICATION – Brush – Roller – Spray Do not apply in temperatures below 40°F. Keep from freezing.
EQUIPMENT CLEAN UP – Water
PACKAGING – Gallons – 5 Gallon Pails – 55 Gallon Drums
FLASH POINT – None
GRIND (HEGMAN) – 4
| COLOR | % TOTAL SOLIDS | % PIGMENT SOLIDS | % VEHICLE SOLIDS | % VOLUME SOLIDS | CONTRAST RATIO |
|---|---|---|---|---|---|
| White | 72.5 | 63.8 | 8.7 | 53. 1 | — |
