U-66 POLYURETHANE

Wood, metal, plaster or concrete, interior or exterior. Equipment in factories, dairies, plating room, chemical plants, institutions, masonry storage tanks, etc.

PROPERTIES & ADVANTAGES – A two component chemically curing polyurethane pigmented enamel, highly resistant to solvents, certain chemicals, mold, acid fumes, and fungus.

FINISH – 60° Gloss – 85+ (Gloss)

COLORS – As desired

SPREADING RATE – After intermix with activator; 640 sq. ft. at 1 mil dry film thickness

DRYING TIME – 2 hours tack free 4 hours dry

VISCOSITY – After inter-mixing, variable with time & temperature

THINNING – U-30 Polyurethane Reducer

SURFACE PREPARATION – Surface must be clean, dry and free of wax, grease, oil and loose scaly paint. For new work on wood, masonry or plaster use U-66 Polyurethane as its own undercoat followed by 1 or 2 coats as desired. Bare metal should be primed with TCB Epoxy Zinc Chromate Primer followed by 1 or 2 coats of U-66 Polyurethane Enamel as desired. U-66 Polyurethane Enamel must be mixed with Urethane Activator before use as follows: Two parts U-66 Poly- urethane Enamel to 1 part U-60 Polyurethane Activator. Mix thoroughly and let set 30 minutes before using. The pot life of this mixture is approximately 8 hours @ 70°F. Care should be taken to mix no more than can be used in this period of time.

APPLICATION – Brush – Roller – Spray

EQUIPMENT CLEAN UP – U-30 Polyurethane Reducer

FLASH POINT – 80° F

GRIND (HEGMAN) – 7

PACKAGING – Gallons – 5 Gallon Pails – 55 Gallon Drums